Sealey EU908 Manuel d'utilisateur télécharger pdf (Page 33)

CMDTCs

P0046

Battery voltage high

Status-60(No additional fault

symptom available for this DTC).

P0098

Intake air temperature sensor 2

Circuit high input

Save

Figure 5.26

You can save the code results for later review by selecting Save

option on the bottom. When you finished viewing the DTCs, press

the ESC button to return to previous screen.

B. Erase Codes

After reading and / or reviewing the diagnostic trouble codes, use

the following steps to erase the codes from the vehicle. If Erase

Codes is not an available menu option, consult the manufacturer’s

service manual for the correct “clear code” method.

NOTE: This Erase Codes function clears the DTCs from the

selected ECU or provides instructions for how to manually clear

the codes from the ECU.

NOTE: Before performing this procedure, make sure the vehicle’s

ignition key is in the On (Run) position with the engine off.

To Erase DTCs, please follow these steps:

1. With the Function Menu screen displayed (Figure 5.23), click

on Erase Codes. The scan tool displays an instruction message.

2. Follow the instructions on each screen that appears until the

procedure is complete.

3. When finished, press any key to exit.

4. Use Read Codes function to check the codes again to see if

DTCs have been erased successfully. If any codes remain,

repeat the Erase Codes steps.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 87 88

Pas de commentaire

Sealey EU908 Manuel d'utilisateur Page 33