INSTRUCTIONS FOR:GALVANIZED STEEL SHED GREEN3 x 3 x 2.1mMODEL No: GSS3030G WARNING! Ensure Health & Safety, local authority, and general worksho
8.1.5. Now x the 35R and 35L mid wall channels to the panel assembly using self tapping screws from the outside (as indicated in the previous diag
8.2.2. Ensure that the panel is adequately supported in the shaded area (as seen below) when screwing the channel connectors (66) into place. 8.2.3
8.3.2. Attach channels 27F, 27E, 27A and 27B to the roong panel using self tapping screws. Note that channels 27A & 27B should be attached to
8.4. ASSEMBLE THE FRONT WALL PANELS.8.4.1. Attach component 41C (jamb) to panel 13L and component 41B (jamb) to panel 13R using self tapping screws,
8.5. ASSEMBLE THE FRONT DOOR.8.5.1. Fix barrel bolt 74 and plate 75 onto door 5L by rivetting them into place. 8.4.3. Now x mid wall channels 33L an
8.5.2. Lay the doors 5L and 5R onto the front wall panel in the open position and open the hinges so that they lie against the frame. Align the h
8.6. FIX THE WALL PANELS TOGETHER.8.6.1. Now x the front, rear and side panels together using 4 self tapping screws at each corner. Fix a pair of ga
8.6.2. Take the two ridge beams (73) and place together the ends marked with a red arrow. Place the ridge beam connector (67) over the joint and align
8.6.4. Place the roof panel with ridge beam attached onto one side of the shed and slide it up the gable ends until it is in position. Ensure th
8.6.5. Attach an end cap (64) to each end of the ridge beam using 16mm self tapping screws.8.6.6. Now bolt the shed to the concrete base using the 11
4. CONCRETE SLAB 5. TOOLS REQUIRED Concrete Slab: It is recommended that your new shed is secured to a concrete slab as shown below. Please ens
8.6.7. Push a safety cap (L) into the exposed ends of the two mid wall channels 35R & 35L that appear either side of the doorway. Soft plastic
Original Language Version © Jack Sealey LimitedGSS3030G Issue: 1 - 28/08/14
Original Language Version © Jack Sealey LimitedGSS3030G Issue: 1 - 28/08/14
Original Language Version © Jack Sealey LimitedGSS3030G Issue: 1 - 28/08/14
Original Language Version © Jack Sealey LimitedGSS3030G Issue: 1 - 28/08/14
7. PARTS DIAGRAM Original Language Version © Jack Sealey LimitedGSS3030G Issue: 1 - 28/08/14
8. ASSEMBLY8.1. ASSEMBLE THE REAR WALL PANELS: 8.1.1. You will nd it easier to assemble the shed using sawhorses with timber studding attached as
8.1.4. Fix the channels in place using self tapping screws as shown below and apply a channel connector (66) to the top and bottom of the panel
Commentaires sur ces manuels